Yamaha XJR1300(L) 99, Руководство по обслуживанию

Страница: 240 / 338

6-26
CHAS
FRONT AND REAR BRAKES
WARNING
NOTE:
WARNING
CAUTION:
NOTE:
EAS00598
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER
Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake com-
ponents.
Recommended brake fluid
DOT 4
1. Install:
brake master cylinder 1
Install the brake master cylinder holder with
the “UP” mark facing up.
Align the end of the brake master cylinder
holder with the punch mark
a
on the handle-
bar.
First, tighten the upper bolt, then the lower bolt.
Brake master cylinder bolt
10 Nm (1.0 m kg)
2. Install:
copper washers (New) 1
brake hose 2
union bolt 3
Union bolt
30 Nm (3.0 m kg)
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
“CABLE ROUTING”.
When installing the brake hose onto the
brake master cylinder make sure that the
brake pipe touches the projection
a
as
shown.
Turn the handlebar to the left and to the right to
make sure that the brake hose does not touch
other parts (e.g., wire harness, cables, leads).
Correct if necessary.