Yamaha FJR13AG, Руководство по обслуживанию

Страница: 567 / 784

FUEL INJECTION SYSTEM
8-90
1 Connection of crankshaft posi-
tion sensor coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Crank the engine, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”
→
Go
to item 7 and finish the service.
Condition is “Detected”
→
Go to
item 2.
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins). Improperly connected
→
Con-
nect the coupler securely or re-
place the wire harness.
Crank the engine, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”
→
Go
to item 7 and finish the service.
Condition is “Detected”
→
Go to
item 3.
3 Wire harness continuity. Open or short circuit
→
Replace
the wire harness.
Between crankshaft position
sensor coupler and ECU cou-
pler.
gray/white–gray/white
Between crankshaft position
sensor coupler and joint cou-
pler.
black/blue–black/blue
Between joint coupler and ECU
coupler.
black/blue–black/blue
Crank the engine, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”
→
Go
to item 7 and finish the service.
Condition is “Detected”
→
Go to
item 4.
4 Installed condition of crankshaft
position sensor.
Check for looseness or pinch-
ing. Improperly installed sensor
→
Reinstall or replace the sensor.
Refer to “GENERATOR AND
STARTER CLUTCH” on page
5-31.
Crank the engine, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”
→
Go
to item 7 and finish the service.
Condition is “Detected”
→
Go to
item 5.
5 Defective crankshaft position
sensor. Check the crankshaft position
sensor.
Refer to “CHECKING THE
CRANKSHAFT POSITION
SENSOR” on page 8-258.
Replace if defective. Crank the engine, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”
→
Go
to item 7 and finish the service.
Condition is “Detected”
→
Go to
item 6.
6 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-250. Service is finished.
Fault code No. P0335
Item
Crankshaft position sensor: no normal signals are received from the
crankshaft position sensor.