Yamaha F30A 2018, Руководство по обслуживанию

Страница: 242 / 348

8-22
Drive shaft and lower case
b. Apply the specified pressure. Check that
the pressure is maintained in the lower unit
for 10 seconds or more.
Do not overpressurize the lower unit. Oth-
erwise, the oil seals could be damaged.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Installing the lower unit
• Make sure to disconnect the battery ca-
bles from the battery, and remove the clip
from the engine shut-off switch.
• When installing the lower unit with the
power unit installed, make sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could fall suddenly and
result in severe injuries.
• When loosening or tightening the propel-
ler nut, do not hold the propeller using
your hands.
1. Check that the pin “a” is aligned with the
alignment mark “b” on the shift bracket “1”.
2. Set the gear shift to the N position.
3. Install:
• Dowel pin “1”
• Speedometer hose “2”
• Hose joint
• Plastic tie
• Lower unit
• Lower case mounting bolt “3”
• Lower case mounting bolt “4”
• Trim tab “5” (original position)
• Anode “6”
Lower unit
Holding pressure
68.6 kPa (0.69 kgf/cm², 9.9 psi)
1
a
b
Shift rod socket “1”
90890-06681
Shift rod socket “1”
YB-06681
Lower case mounting bolt “3” and
“4”
40 N·m (4.0 kgf·m, 30 lb·ft)
R
N
F
1
New
1
1
2
3
3
3
4
5
6
T
R
.
.