Yamaha F30A 2018, Руководство по обслуживанию

Страница: 234 / 348

8-14
Drive shaft and lower case
3. Remove:
• Taper roller bearing outer race “1”
• Shim(s) (T3) “2”
• Drive shaft sleeve “3”
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Heat the area of the lower case where the
tapered roller bearing outer race is to be
removed using a gas torch, and then re-
move the tapered roller bearing outer race
“1”, forward gear shim(s) “2” and the drive
shaft sleeve “3”.
When heating the lower case, heat the en-
tire installation area evenly. Otherwise, the
paint on the lower case could be burned.
TIP:
• Before removing the taper roller bearing out-
er race “1”, place some cushioning material
under the lower case to catch the outer race
when it falls out.
• If the taper roller bearing outer race does not
come out, lightly tap the lower case with a
plastic hammer.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Checking the shift rod
1. Check:
• Shift rod
Bent/worn

Replace.
Checking the pinion
1. Check:
• Teeth of the pinion
Cracked/worn

Replace.
Checking the forward gear
1. Check:
• Teeth and dogs of the forward gear
Cracked/worn

Replace.
Checking the drive shaft
1. Check:
• Drive shaft
Damaged/worn

Replace.
2. Measure:
• Drive shaft runout
Above specification

Replace.
Checking the lower case
1. Check:
• Lower case
Cracked/damaged

Replace.
1
2
3
Drive shaft
Runout
0.5 mm (0.020 in)