Yamaha F115D, Руководство пользователя

Страница: 38 / 82

Operation
33
3. Turn the main switch to “ ” (on).
NOTE:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4. Turn the main switch to “ ” (start),
and hold it for a maximum of 5 seconds.
5. Immediately after the engine starts, re-
lease the main switch to return it to “
”
(on).
CAUTION:
ECM00191
●
Never turn the main switch to “ ”
(start) while the engine is running.
●
Do not keep the starter motor turning
for more than 5 seconds. If the starter
motor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to “
” (on), wait
10 seconds, then crank the engine
again.
EMU27670
Warming up engine
EMU27710
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure warning in-
dicator goes off after starting the engine.
3. Check for a steady flow of water from the
cooling water pilot hole.
CAUTION:
ECM00210
●
If the low oil pressure warning indicator
does not go off after the engine starts,
stop the engine. Otherwise serious en-
gine damage could occur. Check the oil
level and add oil if necessary. Consult
your Yamaha dealer if the cause for the
low oil pressure warning indicator can-
not be found.
●
A continuous flow of water from the pi-
lot hole shows that the water pump is
pumping water through the cooling
passages. If water is not flowing out of
the pilot hole at all times while the en-
gine is running, overheating and seri-
ous damage could occur. Stop the
engine and check whether the cooling
water inlet on the lower case or the
cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
START
ON
ZMU04590