Yaesu VX-6E, Руководство по эксплуатации

Страница: 52 / 111

VX-6E O
PERATING
M
ANUAL
50
3. Rotate the DIAL knob to select Set Mode Item 57: SKIP SKIP SKIP SKIP SKIP .
4. Press the [
0
(
SET
)] key momentarily to enable adjustment of
this Set Mode Item.
5. Rotate the
DIAL
knob so as to select “ SKIP SKIP SKIP SKIP SKIP .” The current Memory
Channel will now be ignored during scanning. The “
ONLY ONLY
ONLY ONLY ONLY ” se-
lection is used for “Preferential Memory Scan,” described in the
next section.
6. When you have made your selection, press the
PTT
key to save the setting and exit to
normal operation.
When you recall the “skipped” memory channel manually, a small
“
X ” icon will appear at the left of the memory channel number, indi-
cating it is to be ignored during scanning. It is still available for
recall manually, however, using the
DIAL knob or keyboard.
To re-institute a channel into the scanning loop, select “
OFF OFF
OFF OFF
OFF
” in step 5 above.
Preferential Memory Scan
The VX-6E also allows you to set up a “Preferential Scan List” of channels which you can
“flag” within the memory system. These channels are designated by a blinking “
X
” icon
when you have selected them, one by one, for the Preferential Scan List.
Here is the procedure for setting up and using the Preferential Scan List:
1. Recall the Memory Channel which you wish to add to the Preferential Scan List.
2. Press the [
F/W
] key, then press the [
0
(
SET
)] key to enter the Set mode.
3. Rotate the
DIAL
knob to select Set Mode Item 57: SKIP SKIP SKIP SKIP SKIP .
4. Press the [ 0
(
SET
)] key momentarily to enable adjustment of
this Set Mode Item.
5. Rotate the DIAL knob so as to select “
ONLY ONLY
ONLY ONLY ONLY .”
6. When you have made your selection, press the
PTT
key to save
the settings and exit to normal operation.
7. To remove a channel from the Preferential Scan List, just repeat
the above procedure, rotating the DIAL knob to select “ OFF OFF OFF OFF OFF ” in step 5 above.
To initiate Preferential Memory Scan:
1. Press the [
V/M
(
DW
)
MT
] key momentarily to enter the Memory Recall mode, if you
are not using memories already.
2. Rotate the DIAL to select any channel which has a blinking “ X ” icon appended to the
channel number.
3. Press and hold in the [ BAND
(
SCN
)
BND DN
] key for one second, and rotate the
DIAL
knob while holding in the [ BAND
(
SCN
)
BND DN
] key to select the desired Memory
Scan mode. Available selections are ALL CH, TAG1, TAG2, BAND, and PMS-X.
M
EMORY
S
CANNING
S
CANNING