63
S
c
a
n
n
in
g
Searching for signals
Canceling scanning
Press
[PTT]
on the microphone to cancel scanning (this does not put the transceiver
into transmit mode).
Selecting the receiver operation performed after scanning stops
Select one of the following 3 receiving operations to be performed after the scanning
stops.
(1) Restart scanning after receiving the frequency for the set amount of time. Select
from 1, 3 or 5 seconds.
(2) Continue receiving the frequency until the signal disappears, and then restart
scanning 2 seconds after the signal disappears (BUSY).
(3) Stop scanning and receive that frequency (HOLD).
1
Press and hold
for over one second.
The Setup menu appears.
2
Rotate the DIAL to select
[5 SCAN]
, then press
.
The menu list appears.
3
Rotate the DIAL to select
[
3
SCAN RESUME]
, then
press
.
The options for receiver operation appear.
4
Rotate the DIAL to select the desired receiver
operation, then press
.
5sec”
Tip
The default setting: 1 BUSY
5
Press and hold
for over one second.
The receiver scanning operation is set, and the display returns to the previous
operating screen.
Tip
The settings here are applied for “VFO Scan”, “Memory Scan” and “Programmable Memory Scan”.
