S
c
a
n
n
in
g
Searching for signals
Memory scan
Frequencies registered to the memory channels can be scanned in the memory channel
number order.
1
Switch to memory mode.
2
Press and hold
[UP]
or
[DWN]
on the microphone for
over one second.
Pressing
[UP]
scans the memory channels in an
upward direction.
Pressing
[DWN]
scans the memory channels in a
downward direction.
During scanning, the decimal point of the frequency
display blinks.
Once the transceiver receives a signal, the
transceiver continuously receives it until the signal
disappears, and restarts scanning 2 seconds after
the signal disappears.
Tips
• The scanning direction (UP/DOWN) can be set from
[5
SCAN]
[2 SCAN DIRECTION]
in the Setup menu.
(This direction setting is also applied to scanning
performed using one of the
[P1]
to
[P4]
keys on the
microphone. The
[SCAN]
function can be assigned
to the key in advance using
[8 CONFIG]
[10 MIC
PROGRAM KEY]
in Setup menu).
• The scanning direction can be changed by pressing
and holding
[UP]
or
[DWN]
for over one second on the
microphone or rotating the DIAL during scanning.
• The receiver operation after scanning stops can be set
from
[5 SCAN]
[
2
SCAN RESUME]
in the Setup
menu (refer to the previous page).
• Press
, and then rotate the DIAL to adjust the
squelch level, even during scanning.
Canceling scanning
To cancel scanning, press
[PTT]
on the microphone (this does not put the transceiver
into transmit mode).
