Yaesu FTM-100DR, Руководство по эксплуатации

Страница: 28 / 176

28
In
s
ta
lla
tio
n
a
n
d
C
o
n
n
e
c
tio
n
Connecting the power supply
Connecting the car battery
When using the transceiver as a mobile unit, connect the DC power supply cable to the
car battery.
Cautions
is connected to the car body.
Check the car battery specification is 12 V. Do not connect the transceiver to the 24 V battery of a
large vehicle.
Do not use the cigarette lighter socket inside the car as a power source.
(1) Cabling from inside the car to the engine compartment
Rout the DC power supply cable to the engine compartment passing it through a
grommet.
1
Feed a stiff wire from the engine compartment through the grommet into the car.
2
Twist the “bare wire” end of the supplied DC power supply cable around the end of
the “feed” wire.
3
Bend the ends of the wires and wind insulation tape around them.
4
Pull the “feed” wire back into the engine compartment.
The DC power supply cable is pulled into the engine compartment.
5
Peel off the tape and remove the DC power supply cable from the wire.











