Yaesu FT-50, Инструкция по эксплуатации

Страница: 32 / 61

sub channels briefly switch as this occurs). For
dual watch, the sub channel is sampled much faster
(every 200 ms), and this checking is “transparent” to
the operator.
If a signal appears on the subchannel, two beeps
sound, the receiver jumps to the subchannel, then
the decimal on the display blinks. Dual watch
resumes according to how you set the scan-resume
mode (5
or carrier drop).
Otherwise, you can operate on the main channel
VFO, or select other memories. If you wish to talk on
the subchannel, press
or to cancel dual
watch operation, then the
Note that you can use any memory as a subchannel
for
V/M
Dual Watch, but only memory I for
You can use Memory Tune during Dual Watch, if you
activate Memory Tune first, although it may be easier
to copy the memory into a VFO instead. You cannot,
however, switch or between memory and VFO
operation (pressing the necessary buttons cancels
Dual Watch).
If you want to talk on the subchannel, you have to
recall it, or press
to quit Dual Watch operation.
Naming Memories
You can assign a name of up to 4 characters to
memories, and have it displayed with name or fre-
There are 48 different characters for nam-
ing, including a space and 11 special symbols.
Before naming a memory, first store its frequency
and other settings as described previously, then:
Press and select the memory you wish to
name. Hold the knob for second, then turn it to
display
Press the knob momentarily, then turn it so that
appears at the right. If this memory has been
named previously, that name now appears at the
left. Otherwise, the left side is blank.
Press the knob again momentarily; appears to
the right, with an blinking underline cursor appear-
ing at the left-most digit location. Turn the knob to
select a character.
- - - -
‘ I ’
With the desired character displayed, press the
knob momentarily. The cursor moves one digit to
the right. Turn the knob to select the next character.