Yaesu FT-50, Инструкция по эксплуатации

Страница: 42 / 61

To enable auto-respond paging:
Recall , press the knob momentarily,
then turn it to select .
Press the knob momentarily again to display the
current answer-back mode: , or
Turn the knob to select the desired mode, then
press the to save the change and exit.
Now, with either auto-respond mode enabled, the
transceiver reacts to a valid page call by answering
or forwarding the DTMF page sequence, according
to selected mode.
Paging Transmit
When calling other stations using DTMF paging or
DTMF code squelch (particularly through repeaters),
you may find that some stations are unable to receive
your calls. This can be caused by their squelch not
opening fast enough (after receiving your transmitted
carrier) to allow all of the DTMF digits to be received
and decoded.
To correct this problem, you can set a longer delay
between the time your transmitter is keyed and the
first DTMF digit is sent:
Recall , press the knob momentarily,
then turn it to select
Press the knob momentarily again to display the
current time delay or
This is the delay between the moment your press
the PTT and transmission of the first DTMF code
digit. Set it to ms or ms if operating
through a repeater that cuts off the first digit.
Turn the knob to select the desired delay, then
press the to save the change and exit.
Playback Speed
This selects the tone duration (50 or 100 ms) for each
DTMF paging digit, to select fast or slow playback
speed during paging operation. The 50 ms tone du-
ration are preferable, but the slower tones may work
better under weak signal conditions.
Recall , press the knob momentarily to
display (DTMF code sending speed).
Press the knob momentarily again to display the
current speed setting, and turn it to change the
setting: SO or ms per tone. Press the knob
again (or press the PTT to exit).
Paging Bell
Rotate the knob one click to display (or
press PTT to quit), then press the knob momentar-
ily again to display the current bell setting: I,
3, S
or
rings, (rings until the is pressed), or
Set it to only if you do not want the ringer to
sound (these settings do not affect the CTCSS or
DCS ringer). Press the PTT to exit.