Yaesu FT-50, Инструкция по эксплуатации

Страница: 25 / 61

If you would like to disable the auto-mode selection:
Hold the knob down for second, then turn it to
select
3 I .
Press it again to display the default setting, then
rotate the knob to select or (reception de-
faults to narrow for frequencies). Press the
PTT to save the setting and exit
Reception Mode Override
If you would like to override the mode selection
temporarily while receiving on a channel, you can
enable this feature. Auto-mode selection takes effect
again as soon as you turn the knob and change the
channel (unless you have it disabled NFM only).
Hold the knob down for second, then turn it to
select
Press it again to display the default setting, then
rotate the knob to select , or . Press
the PTT to save the setting and exit.
Repeater Operation
Fortunately, repeater operation usually requires just
tuning to the correct channel, pressing the PTT, and
speaking. The ARS (automatic repeater shift) feature
sets the correct shift and offset as you tune through
the 2-m and 70-cm repeater sub-bands. You can
observe the and indicators activate and change
as you tune across the amateur band. The chart
shows the ARS ranges for common transceiver ver-
sions.
ARS-Repeater Subbands
Version A
2-m
146.6
146.4
, ,
Version
V e r s i o n A + _ _
1 .
Euro 2
ARS is enabled at the factory. To disable it:
Hold the knob down second, then turn it to
display
. Now press it again momentar-
ily, and turn it to select
Press the PTT to accept your setting and return
the display to the operating frequency.
You can still manually select a new shift, if ARS is
activated or not. However, if you change frequency
with ARS activated, manual repeater shift selections
are terminated and the ARS shifts are restored.
Setting Repeater T
X
Offset
Although you should keep the repeater offset pro-
grammed to that used in your area, you can change
the default repeater offset for special applications:
Hold the knob down for second, select
, the press it again to display the offset.
Turn the knob to select the new shift offset fre-
quency (selectable in increments only).
Press the PTT to save the setting and exit.