Yaesu FT-50, Инструкция по эксплуатации

Страница: 28 / 61

MR -> VFO (copying a memory into a VFO)
After storing memories, you may want to copy one
back to a VFO. You can copy the current memory into
the last-used VFO by holding for second, and
pressing
HOME Memory
Although invisible to the procedures just described,
the HOME memory can be instantly recalled by
pressing appears above the fre-
quency at the left. There is a default simplex fre-
quency stored in the HOME memory, but you can
reprogram it with any frequency, repeater, power,
and tone settings, or even a separate transmit fre-
quency.
To copy the displayed VFO settings into the HOME
memory, hold for second until the right half of
the display blinks, then press
Custom T
X
Offset
All memories can store an non-standard tx offset, for
operation on repeaters with non-standard shift. To do
this:
Store the receive frequency using the method al-
ready described under Memory Storage
(any repeater offset will be ignored).
Tune to the desired transmit frequency, then press
and hold for second to display a slot at the
right.
Press and ho/d the switch while pressing
momentarily (this does not key the transmitter). Or
course, if you’re storing this in the HOME channel,
you press
when holding the PTT).
When a separate transmit frequency memory is
appear at the top left corner. You can
press to display the transmit frequency,
while the pair are reversed.
After storing a memory with a separate transmit fre-
quency, if you rewrite the receive frequency in that
memory, the separate transmit frequency is deleted.
Memory Tuning
MT
While receiving on a memory, you can re-tune it and
change any other settings:
First press so that can tune it like
a VFO.
To store the new frequency and settings in the
current or other memory, hold for M-second,
select the new slot (if desired), and press
Operation remains on the new memory, as the old
memory is restored.
After re-tuning a memory, to discard your changes,
press to restore the original memory data.