Yaesu FT-50, Инструкция по эксплуатации

Страница: 20 / 61

This angle of PTT switch actuation is designed to be
ergonomically optimum when the radio is being held
in the palm of your hand.
When you transmit, the
BUSY/TX
LED turns red, and
all or a few of the meter bar-segments appear, de-
pending on your transmit power. One of four power
output levels can be selected using either the keypad
or menu method:
From the menu:
Hold
the
knob down to recall the menu list, then
turn the knob one click so that :: ap-
pears.
Press the knob once to view the default power
level, then rotate the knob to select I,
I
?, 3, or
Press the PTT to save the change and exit.
Refer to the following table for power output vs.
battery type:
Display
Code
PO Meter
Segments
watts) VHF/UHF
shortcut for selecting high/low tx power:
Pressing only lets you toggle between
high and
low power
(
LOW
displayed when active). The low
power level will correspond to that set previously in
Remember! - good operating practice and profes-
sional courtesy mean using the least transmit power
needed to maintain communications.