xLab XDP-321, Руководство пользователя

Страница: 37 / 69

x-Lab Dot Matrix Printer XDP-321 User's Manual
- 30 -
ENG PITCH Specify the ASCII character spacing in characters per inch (cpi).
CHI PITCH Specify the Chinese character spacing in characters per inch (cpi).
INTL CHAR SET
Specify the printer internal character set according to different using
circumstances of international characters.
CHARACTER SET Specify character set as Italic Character or Graphic Character.
IBM CHAR TBL
Select IBM character table 1, which the position from 80H to 90H of character
table are control codes.
CODE PAGE Select the code page according to different national characters use
circumstances.
LINE SPACING
Specify the line spacing in lines per inch (lpi). If the print data with vertical pitch
instruction, printer would give priority to print data instruction.
FORM LENGTH
Specify the page length of the form, for both cut sheet and continuous paper.
Printer feeds to next page according to the specified page length. If the print data
with page length instruction, printer would give priority to print data instruction.
FORM LOCK
After selecting this function on, printer would lock the page length setting. Printer
feeds to next page according to the current setting parameter and would not
affected by the page length instruction of the print data.
PAGE SKIP
After selecting this function on, printer would leave one inch (25.4mm) margin at
the perforation of the tractor paper automatically. If the print data with page
margin instruction, printer would give priority to print data instruction.
COMPRESS
PRINT
After selecting this function on, printer would print out transverse compressed
content according to the specified percentage in normal speed. When
auto-compress mode is selected, printer would detect paper width automatically
and choose the proper percentage to print.
PRINT DIR
Select the printing direction of the print head: unidirectional, bidirectional or
selected via software.
PRT-SPEED
Specify the print speed of printer. Printing resolution is lower while print speed is
higher.
AUTO LF
If this function is on, printer would advance the paper one line automatically after
receiving every carriage return instruction.
TEAR OFF
Select the function of feeding the paper to tear off position ON or OFF in tractor
paper mode. After selecting this function on, if the printer receives FF command
for a period of time, but receives no printing data, printer would feed the page
bottom to tear off position automatically.
TEAR POS
After selecting this function on, when the printer has finished printing, paper
would be fed to the set tear off position automatically, and you should tear off the
paper manually.
PIN SWITCH
After selecting this function on, printer would switch different pins to print table
line automatically.
IMPACT MODE According to customer's printing requirement, select the printing capability.
BAUD RATE Specify the printer serial data transfer rate.
PARITY Specify the parity bit for serial data transfer.
DATA BIT Specify the serial data bits.
STOP BIT Specify the serial data transfer stop bit.
PROTOCOL
Specify the protocol of printer serial data transfer as software control
(XON/XOFF) or hardware control (DTR).