x-Lab Dot Matrix Printer XDP-321 User's Manual
- 19 -
4. Slide the left guide track until it reaches the triangular guide mark. Next, adjust the right guide track to
match the width of your paper. (As shown in Figure 3-4)
5. Slide a sheet of paper down firmly between the guide tracks until it meets resistance. The printer
loads the sheet automatically. (As shown below)
6. Adjust the printing home position according to the steps in Micro-Adjust of Printing Home Position and
Tear-off Position if necessary.
3.1.2 Loading Tractor Paper
If you use the tractor paper, you must decide which tractor to be installed. Then you install the tractor in
the corresponding way.
For convenience to switch between printing on cut sheet and tractor paper, or for convenience to tear
off the tractor paper, you should use the tractor in push position. The printer leaves the factory with the
tractor installed in this position as the default setting.
Figure 3.1.1-3 Raise the paper guide upright
Figure 3.1.1-4 Adjust the guide tracks
Figure 3.1.1-5 Insert cut sheet
Note: Don’t feed paper with Paper feed knob, or it will influence the precise paper feeding
position.
