x-Lab Dot Matrix Printer XDP-321 User's Manual
- 9 -
5. Press the
ONLINE
button to pause the printing.
6. After the printer finishes printing, press
LF/FF
button or
LOAD/EJECT
button to eject cut sheet,
and then turn off the printer to exit self test mode.
1.9 Connecting to Your Computer or Other Equipment
The printer can be configured with parallel interface, USB interface or serial interface (Please take the
specific interface as standard). Connect the printer to the computer with the correct cables. Before you
begin, place the printer upright, as shown below.
ASCII Self-test mode
x-Lab XDP-321 VX.X 20XX/XX/XX
!"#$%&’( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`ab
!"#$%&'( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abcd
"#$%&'( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abcde
e
Serial interface
USB interface
Parallel interface
Figure 1.8-4 Load cut sheet
Figure 1.8-6 ASCII self-test mode
Figure 1.9 Lay the rear side of printer upwards
Warning: The window must be closed while printing.
Note: If you do not satisfied with the print result, see Chapter 4. If it prints correctly, go on
to the next section.
Note: Before connecting the parallel interface cable or the serial interface cable, please
make sure the power of the printer is shut down. Only after tightening the cable may
you turn on the power, or it will damage the printer.
