VCU1287 Characterization Board
www.xilinx.com
10
UG1121 (v1.0) December 11, 2015
Chapter 2:
Board Setup and Configuration
Table 2-1:
VCU1287 Board Components
Callout
Reference Designator
Feature Description
1
U1
Virtex UltraScale XCVU095-FFVB2104E Device
2
SW1
Power Switch
3
J28
12V mini-fit connector (
12V Input Power
)
4
J37, J155, J38, J80, J39,
J82, J141, J142, J71
GTY transceiver connector pads Q124, Q125, Q126, Q127, Q128,
Q129, Q130, Q131, Q132 (
MGT Transceivers and Reference
Clocks
)
5
J40, J88, J89, J41, J42,
J92, J43, J156, J143, J68
GTH transceiver connector pads Q224, Q225, Q226, Q227, Q228,
Q229, Q230, Q231, Q232, Q233 (
MGT Transceivers and
Reference Clocks
)
6
U80
Digilent USB JTAG connector (micro-B receptacle) (
A list of
jumpers and switches and their required positions for normal
board operation is provided in Appendix A, Default Jumper
Settings.
)
7
J2
Platform USB JTAG connector (alternate access for programming
cables) (
A list of jumpers and switches and their required
positions for normal board operation is provided in Appendix A,
Default Jumper Settings.
)
8
J10
SD card connector (back-side of board) (
A list of jumpers and
switches and their required positions for normal board
operation is provided in Appendix A, Default Jumper Settings.
)
9
SW13
System Controller Configuration DIP Switches
10
SW4
System Controller Reset
11
J36
SuperClock-2 Module
12
U42
300 MHz LVDS Oscillator
13
DS17
FPGA DONE status LED (
DONE LED
)
14
DS3
FPGA INIT_B status LED (
INIT LED
)
15
SW7
FPGA PROG_B pushbutton (
PROGRAM Pushbutton
)
16
DS18
12V power status LED (
Power Switch
)
17
DS4, DS5, DS6, DS7,
DS8, DS9, DS10, DS11,
DS13, DS14, DS15,
DS28, DS29, DS30,
DS32
Status LEDs for FPGA logic, transceiver, and utility power
18
SW2
Power regulation inhibitor switch for onboard regulators (
Using
External Power Sources
)
19
J5, J18, J19, J20, J22,
J23, J26, J27, J67, J69
External power supply connectors (
Using External Power
Sources
)
20
J93, J138
Bank 124-132 GTY transceiver power supply module (
Onboard
Power Regulation
and
A list of jumpers and switches and their
required positions for normal board operation is provided in
Appendix A, Default Jumper Settings.
)
Send Feedback