XEV Y0210, Руководство пользователя, Страница: 52 / 142

44
充电装置
Wiper
Front windshield wiping
./
25
/4:
3/9:
5,,
When the start switch is "ON", the wiper
and washer at the front windshield can
be operated.
1
OFF: initial position, turn the wiper
switch upward from the initial position
OFF as follows:
2 INT: Intermittent
3 LO: Low speed
4 HI
：
High speed
Flip the wiper switch upward from the
initial position to the "MIST" position, and
the wiper will automatically return to the
initial position after each wiping.
./
25
/4:
3/9:
5,,
To adjust the intermittent speed of the
wiper, flip the wiper switch upward from
the initial position OFF to the INT
position.
Flip the wiper switch upward from the
initial position OFF to the LO position,
then the wiper will run at a low speed.
Flip the wiper switch upward from the
initial position OFF to the HI position,
then the wiper will run at high speed.
Put the wiper switch at the OFF position,
wiper is not at the initial position, the
wiper will automatically return to that po-
the initial position in the low speed. Set
the start switch to the ON state, if the
sition at low speed.
Flip the wiper switch upward from the
initial position OFF to the position HI, and
the wiper will run at high speed.
Put the front wiper gear switch in the
OFF position, and the front wiper brush
will automatically return to the position in
the low-speed wiper mode.Set the key to
the ON state. If the front wiper brush is
not ON the return point, the wiper will
automatically return to the position at low
speed.
Flip the wiper switch upward from the ini-
tial position OFF to the position HI, and
the wiper will run at high speed.
Put the front wiper gear switch in the
OFF position, and the front wiper brush
will automatically return to the position in
the low-speed wiper mode.Set the key to
the ON state. If the front wiper brush is
not ON the return point, the wiper will au-
tomatically return to the position at low
speed.
Washer operation
./
25
/4:
3/9:
5,,
Washing/wiping
If the wiper switch is at OFF or INT
position, the wiper will start to work
continuously at a slow speed after 0.4s.
If the wiper switch is at LO or HI
position, the wiper will remain keep the
original working state.
For washing, the wiping cycle can be
adjusted according to the
water spray
amount: if the washing switch is on for
less than 300ms, the wiper will stop
for over 800ms, the wiper will stop after
then the wiper will automatically return to
after a cycle; if the washing switch is on
2 cycles; if the washing switch is always
on, the wiper will continue to wipe, until
the washing switch is off.
Instrument and control