Xerox WorkCentre Pro 423, Руководство по обслуживанию

Страница: 327 / 619

03/02 4.3 Adjustment
WorkCentre Pro 432/428 4-53 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
•
l Lead Edge …… 6/93
Min Nominal Max
Set range 0
0mm 61
2mm 94
4mm
Changes 0.0423mm / 1Step
•
l Trail Edge …… 6/94
Min Nominal Max
Set range 0
-17.5mm 94
2mm 175
26mm
Changes 0.26mm / 1Step
•
l Side Edge (Rear) …… 6/92
Min Nominal Max
Set range 0 57 94
Changes 0.0423mm / 1Step
•
l Side Edge (Front) …… 6/91
Min Nominal Max
Set range 1 73 94
Changes 0.0423mm / 1Step
13. Finisher
ADJ 13.6.1 Adjusting the Paddle Position
Ref. PL: PL13.6
Purpose Optimise the positional relationship between
the Paddle Guide and Gear.
Adjustment
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
•
FAX equipped machines: Ensure that the “Job in
Memory” indicator on the con trol panel goes out.
Press “Job Status:Stop” button and confirm that the
job has cleared from the “Current Jobs” folder.
•
Printer machines: Ensure that “Ready to print or
fax” is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the Rear Cover. (PL13.17)
2. Remove the Finisher Top Cover. (PL13.8)
3. Remove the Paddle Gear. (PL13.6)
4. With the Exit Transport Guide up (initial state), align
the Paddle Guide (resin section) with the convex.
(Figure-1)
(Figure-1) j0hn4d51
5. In the status of Figure-1, position the Paddle Gear
until the Stopper catches the detent, and secure the
Gear at the black Holder projection (PL13.6).
(Figure-2)
(Figure-2) j0hn4d52