Xerox Wide Format 6705 System, Руководство пользователя

Страница: 61 / 363

Before Using the Machine
1
61
1.10 Calibrating the Scan Sensor Gap
1.10.4 Error Code
An error code is displayed if calibration has failed with an error.
Refer to the error codes in the following table to resolve problems.
* Any other codes between 062-701 and 062-754
Error Code Cause Remedy
062-702

The <Stop> button was pressed while the
calibration chart was still being scanned.

A paper jam occurred.

Load the calibration chart again.
062-714

The calibration chart is loaded wrong side up.

The calibration chart is loaded in an incorrect
orientation.

The calibration chart is torn.

Check that the calibration chart is free of dirt and is
not torn, and load it face down on the document
table.
062-713
062-725

The position of the document guide is being
shifted to the right.

The right edge of the calibration chart is not
aligned with the document guide.

The calibration chart was fed skewed.

The calibration chart was not printed in its
entirety or is torn.

Check whether the document guide is at the correct
position.

Check that the calibration chart is free of dirt and is
not torn, and load it face down on the document
table.
062-735

The calibration chart is not being fed at the
constant speed.

Make sure that you do not apply external force on
or pull the calibration chart while it is being
scanned.
Others
*

Auto Adjust failed.

Check the remedies above again, and load the
calibration chart.

If the trouble persists even after performing the
suggested actions, contact your local Xerox repre-
sentative.