Xerox Telecopier 7017, Техническое справочное руководство

Страница: 89 / 194

ADJ 5.2 Scan Registration
Purpose
The purpose is to time the scanner so that both
the lead edge and the trail edge is printed.
Check
N O T E : T h e c u t t e r r e g i s t r a t i o n C h e c k /
Adjustment (ADJ 5.1) must be correct prior to
checking the Scan registration.
1. Clean the following using Xerox CLEAN-
UPS:
a. ADF belt
b. retard roller
c. lower scanner drive rollers
d. platen roller
e. upper scanner idler rollers
2. Make three single copies of test pattern
82P151.
3. Verify the scan registration.
a. Examine copies for tips of the
registration arrows on both the lead
edge and the trail edge.
c. If the copies vary by more than 1 mm,
correct the varying registration
problem (RAP 2.3.6), then recheck
scan registration.
d. If registration arrows on the lead
edge are equal to the registration
arrows on the trail edge (Figure 2),
the scan registration is correct.
e. If registration arrows on the lead
edge are not equal to the ones on the
trail edge (Figures 1 and 3), perform
the scan registration adjustment.
Adjustment
1. Perform the Check to verify that scan
registration needs adjustment.
2. Enter Service Mode.
3. Determine current Systems Data Setup
for cutter registration.
a. Select Menu 22 to print Options
Report.
b. Press the Start button.
c. Highlight Systems Data Setup No. 10
and the corresponding DATA.
4. Determine adjustment needed.
a. Compare the test patterns from the
scan registration check to the test
patterns in Figures 1 through 3.
Continued
12/88
ADJ 5.2
4-52 Telecopier 7017 / 7017SF
www.printcopy.info
www.printcopy.info