Xerox Telecopier 7017, Техническое справочное руководство

Страница: 15 / 194

2.2.5 OPXX Error Codes
Code Meaning Display message Corrective Action (after performing message)
OP03 Invalid telephone number detected TELEPHONE NUMBER ENTERED INCORRECTLY Perform System Check
during pulse dial (#,
*
) PLEASE REMOVE ANY # or
*
-TRY AGAIN OP03
OP05 Store memory full detected. MEMORY CAPACITY EXCEEDED-PLEASE DIVIDE Perform System Check
JOB AND RESEND OP05
OP06 Communication data memory empty THERE IS NO INFORMATION AVAILABLE TO Perform System Check
(Service mode only) REPORT OP06
OP10 Job card not detected in job reserve JOB CARD NOT DETECTED-PLEASE RELOAD JOB Perform System Check
mode. IN INPUT TRAY
OP12 Unauthorized Job Card detected. JOB CARD NUMBER DETECTED DOES NOT MATCH Perform System Check
NUMBER IN JOB MEMORY-PLEASE MATCH OP12
OP13 Start hole/information hole is too long. JOB CARD IS WORN-PLEASE REPLACE WITH NEW Perform System Check
JOB CARD OP13
OP14 Bottom interval is too short. JOB CARD IS WORN-PLEASE REPLACE WITH NEW Perform System Check
JOB CARD OP14
OP15 Hole interval is too long. LONG ORIGINAL OR JAM DETECTED IN Perform System Check
SCANNER-PLEASE REFER TO MANUAL. OP15
OP22 No document detected in ADF. NO ORIGINALS DETECTED-PLEASE RELOAD Perform System Check
ORIGINALS AND TRY OPERATION AGAIN OP22
OP23 Document is sensed by scan position ORIGINAL DETECTED IN SCANNER-PLEASE Check scan output drive belt (RAP 2.3.11),
sensor. REMOVE ORIGINAL FROM SCANNER OP23 scan position sensor (RAP 2.3.8); replace A2
OP24 Misfeed in ADF. ORIGINALS OR JOB CARD DID NOT FEED Check scan input drive belt (RAP 2.3.11),
PLEASE CLEAN FEED BELT & TRY AGAIN OP24 scan position sensor (RAP 2.3.8); replace A2
OP25 Document is too long or jammed. LONG ORIGINAL OR JAM DETECTED IN Perform System Check
SCANNER-PLEASE REFER TO MANUAL OP25
OP32 Recording paper is low or empty. Check low paper sensor (RAP 2.3.8);
(Normal case) RECORDING PAPER LOW-PLEASE REPLACE OP32 replace A2
OP32 Recording paper is low or empty. RECEIVED DOCUMENT IN MEMORY Check low paper sensor (RAP 2.3.8);
(Special case) RECORDING PAPER LOW-PLEASE REPLACE OP32 replace A2
OP36 Recording paper remained by the Perform System Check
jam sensor. (Normal case) RECORDING JAM-CLEAR PAPER PATH OP36
OP36 Recording paper remained by the RECEIVED DOCUMENT IN MEMORY Check printer jam sensor (RAP 2.3.8),
jam sensor. (Special case) RECORDING JAM-CLEAR PAPER PATH OP36 replace A2
8/88
Telecopier 7017 / 7017SF 2-5
OPXX Error Codes
www.printcopy.info
www.printcopy.info