Xerox Telecopier 7017, Техническое справочное руководство

Страница: 6 / 194

24. Image is full size (not reduced).
Y N
| Check wide original sensor (RAP
2.3.8); replace A2.
25. Image is parallel with paper edges (not
skewed).
Y
N
| Check platen belt (RAP 2.3.11).
26. Image quality is acceptable (compare to
test pattern sample in Section 3).
Y
N
| Clean platen glass; replace A2, video
assembly.
27. Set document guides for 11 inches (28
cm).
28. Place test pattern 82P151 into the ADF
face down. Reduction LED comes on.
Y
N
| Check wide original sensor (RAP
2.3.8); replace A2.
29. Press Copy, then press Start. The original
is fed into the Scanner.
Y
N
| Replace A2.
30. Image quality is acceptable (compare to
Wide Original sample test pattern in
Section 3).
Y
N
| Clean platen glass; replace A2, video
assembly.
31. Perform 1.2.3 On-Line System Check.
1.2.3 On-Line System Check
NOTE: Perform this check only after 1.2.2 Off-
Line System Check has been performed.
NOTE: If an error code (COXX, FPXX, EXXX, or
OPXX) appears at any time during this check,
do not continue. Refer to Section 2. for the
Error Code List and perform the actions
indicated.
1. Perform a send operation to a known
good G3 facsimile terminal.
RX NOTE: If listen to dial is not permitted in
your country, go to step 3.
2. Dial tone is heard when terminal goes On
Line.
Y
N
| RAP 2.3.4.
3. Dialing is completed successfully.
Y N
| Replace A10, A2.
4. Terminal transmitted in G3 mode at 9600.
Y N
| Replace A5, A2.
5. After completion of the send operation,
the display indicates:
SEND OPERATION COMPLETE #1
TIME DATE
Y N
| Replace A2, A5, A10.
6. Image quality received at the remote
terminal is acceptable. (Image quality
acceptance is determined by the remote
operator’s perception of quality.)
Y
N
| RAP 2.3.13.
7. Call the terminal from another
telephone. The terminal answers with a
ready tone and the following is displayed
for approximately 3 seconds.
INCOMING CALL
TIME DATE
Y N
| RAP 2.3.5.
8. Perform a receive operation. Terminal
receives normally at 9600 bps.
Y
N
| Replace A10, A2.
9. Image quality is acceptable (refer to
Image Quality Section 3).
Y
N
| RAP 2.3.13.
10. All suspect options and features have
been checked.
Y
N
| Refer to Table 1 to select the
appropriate Additional System
Checks (1.3).
11. Go to Final Actions.
Table 1. Additional System Checks
Suspect Option or Feature Check
G2 mode in send or receive 1.3.1
Store and forward option 1.3.2
Automatic Document Feeder
(multiple originals) 1.3.3
12/88
Telecopier 7017 / 7017SF 1-5
Off-Line System Check, On-Line System Check
www.printcopy.info
www.printcopy.info