Xerox Nuvera 100, Руководство оператора

Страница: 147 / 234

Operator Guide 5-21
Troubleshooting
If the printer is inactive, one of following could have
happened:
• Your job has been transmitted to the printer already.
Continue to step 4.
• Your job has not been queued to the printer. Skip to step
5.
4. Contact the host operator or access the output queue screen
on the host terminal to find out if the job is queued.
• If the job is queued, the Printer State should be ACTIVE.
• If the job is queued and the printer is not ACTIVE, there
may be a problem at the host.
5. Access the log screen on the host terminal to check whether
the job has completed with or without errors.
6. Go to the log screen on the host terminal and see if the job
completed with or without errors. If there was a JCL error in
your job, you see an indication of it.
Data type on the Online Manager window
If the Online Manager window indicates a data type that is not
LCDS when the streaming job is started, this may cause
unpredictable system behavior, such as the window graying out.
Make sure to select LCDS as your data type before submitting a
job.
Streaming queue release setup
When Do Not Release Jobs is specified for the streaming queue,
the Online gateway creates a new job, but does not start
accepting data from the host. This is because the job is not
scheduled while the queue is set up to not release jobs. The
gateway does not start receiving data from the host until the job
is scheduled and the decomposer becomes ready to accept
data. This is not an error or abnormal situation. Change the
queue setting to Release Jobs, and the gateway starts receiving
data normally.