N e t W a r e C o n f i g u r a t i o n
3-4
❖
D o c u P r i n t 4 5 1 2 / 4 5 1 2 N N e t w o r k I n t e r f a c e C a r d U s e r G u i d e
Configuring
NetWare 2.15
and 3.1x
Before configuring the NIC for NetWare, you must determine
if the NIC has its desired name. If you want to change the
name, use NIManage to change the name. Refer to
Using
the NIManage Utility
(page 3-28)
for more details.
The following steps are the general procedure for configuring
the NIC. You must have supervisor privileges to do this
configuration. These steps are covered in detail in the
following paragraphs:
1. Start PCONSOLE and select the file server you want to
use.
2. Create the print queues.
3. Specify the <
print server
> card as a print server.
4. Configure the print server and printer.
5. Assign the print queues.
6. Set up the NOTIFY options.
7. Repeat the procedure for other file servers.
When you are finished, turn the printer off and on again. The
printer creates a status report that indicates the fileservers to
which the unit is attached and the queues which it services.
Before you begin:
Verify that you have supervisor privileges on the file
servers on which the NIC print server is to be entered.
Verify that your version of PCONSOLE is later than 1.0.
Book.frm : Chap3.frm Page 4 Saturday, October 12, 1996 7:43 AM