Xerox DocuPrint 180, Руководство по эксплуатации

Страница: 30 / 356

HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-8 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
HP1299 XPAF communications recovered
HIP can now receive data via the XPAF communication mode. Data
received but not yet written to system disk will be copied from
memory (saved at system error restart) and written to system disk.
The system then reestablishes the communications link and
continues to receive the next block of data.
Action None.
HP1300 Assuming negative confirmation
A confirmation prompt requiring a YES or NO response was
displayed. No response was entered within the system’s time limit.
The system is responding as if N were entered.
Action If the Y response was intended, reenter the command, responding to
the confirmation prompt within the system time frame of 30 seconds.
HP1320 Function is not supported by current host
The requested function cannot be carried out by the current host.
Action None.
HP1325 Command not permitted by current host
You are currently logged on to the system at a level less than 2. The
command you attempted to enter cannot be accepted at your present
level.
Action 1. Log off and then log on at level 2.
2. Refer to the appropriate Xerox DocuPrint 180 LPS Operator
Guide .
HP1330 Buffersize=xxx, utilization=yy% zzzz blocks used, uuuu blocks
available.
This messsage provides the number of blocks available and the
amount of the buffer already used.
Action None.
HP1340 Known and current hip hosts:
This message lists the available and currently-used HIP hosts for
your system.
Action None.
HP1410 End of HIP diagnostic
The HIP command was entered during an interactive diagnostic test,
or the system failed Test 2 or 3. The diagnostic test has been
terminated.
Action None.