Xerox 5400N - Phaser B/W Laser Printer, Справочное руководство по обслуживанию

Страница: 268 / 503

Phaser 5400 Laser Printer Service Guide 239
Reset Menu
The Reset Menu provides functions not normally encountered or needed during
routine service of the printer. Thus, a special action step is required to gain access to
the Reset Menu. Once in the Reset Menu, the following operations can be performed:
■
Restore Factory Defaults (resets front panel menu defaults, except
networking).
■
Restore Network Defaults (resets only the front panel networking defaults).
■
Enter Demo Mode (pressing any front panel key causes the PCL Demo page
to print).
■
Delete all spooled print jobs on an internal Hard Drive (if installed).
■
Initializes the internal Hard Drive (if installed).
■
Formats the Hard Drive (if installed).
Entering Reset Menu
1. To enter the Reset Menu, make certain the printer is switched OFF.
2. Press and hold [0] and [4] while switching printer power ON. Continue pressing
[0] and [4] until asterisks begin appearing across the Control Panel display (LCD).
3. Release [0] and [4].
4. When “Ready” is displayed, press [1] or [5] until “Menus / Reset Menu” appears.
5. Press [2] or [6] to access the six tasks listed above. Each task is actuated using the
same following steps:
■
Press [2] or [6] to scroll to the desired task.
■
Press [3] or [7] to select the desired “Yes / No” choice.
■
Press [4] to enter that choice and make it happen.
0 1 2 3
4
5
6 7
0 1 2 3
On Line Form Feed ! Fault Data
On Line Menu Up Item Up Value Up
4
5 6 7
Enter Menu Down Item Down Value Down
s5400-350
Xerox Phaser™ 5400