WPI NANOLITER2020, Инструкция по эксплуатации

Страница: 34 / 44

30 World Precision Instruments
Disabling Motors for Low Noise Recording
For applications where a low electrical noise environment is necessary, you may turn off
the drive electronics to the motors until you need to use them. When you return to any
other screen, the motors automatically re-enable themselves.
To disable the drive motors on the
NANOLITER2020 pumps, select the Low Noise
Recording check box. When you press the Back button to return to the previous screen, a
warning appears.
Fig. 50—Warning message appears to let you know that the motors will be re-engaged and the
Low Noise Recording period will end.
Press Yes to re-enable the motors and return to the Command screen. Press No to remain
on the System Options page without enabling the motors.
The drive motors are always enabled when the
MICRO2T is powered up. The only time
the motors are disabled is when the Low Noise Recording check box is selected and the
System Options screen is displayed.
Setting Screen Brightness
You may adjust the brightness intensity of the unit’s display by using the Brightness slider.
The unit will always power up with the brightness set to maximum.
Resetting System Defaults
To reset the factory default settings, press Defaults . A message appears to confirm that you
want to load the default settings.
Fig. 51—Warning message appears indicating that you are about to reload the factory default
settings.
Click OK to reload the factory defaults or Cancel to exit without loading the defaults. Press
Back to bring up the Main Menu .
Displaying Firmware Revision
Press About to display the current firmware version running on the instrument. The About
button appears in the upper right corner of the System Options screen. See Fig. 49.