WPI NANOLITER2020, Инструкция по эксплуатации

Страница: 33 / 44

NANOLITER 2020/200704
World Precision Instruments 29
APPENDIX A: MICRO2T CONFIGURATIONS
Selecting System Options
The
System Options
screen gives you immediate access to basic parameters for your
operations. To access the System Options screen:
• Select System Options from the main menu, or
• From the Pump Configuration screen, press Options .
Fig. 49—The System Options screen allows you to set basic system parameters for operations. It
also lets you revert to the factory default setup.
NOTE : Most parameters are stored in memory, even when the controller is powered off.
However, when the unit is powered on, Remote Access is always disabled, and the pump
drive motors are always enabled.
Disabling Sound Feedback
To disable all audio feedback from the MICRO2T, unselect the Sound Enabled check box.
To re-enable the controller sounds, select the Sound Enabled check box. Press Back to save
the setting and bring up the Command screen.
Enabling Remote (Computer) Access
Remote control of the MICRO2T is available through the USB port on the back of the
controller using a terminal access program on a computer. Before the controller can
receive commands from a computer, remote access must be enabled. By default, this is
disabled. To enable remote access:
1. Select the
Remote Access check box.
2. Press Back to save the setting and bring up the Main Menu .
3. Press Display All Channels to bring the Channel Data Display . Remote commands are
only accepted while the unit is on this command screen.
Remote access is always disabled when the MICRO2T is powered up. If you power the
unit off, you will need to reset this parameter in order to operate with remote access. See
“Appendix B: MICRO2T Computer Control” on page 33.