A-1
Appendix A
Channel and Jumper Changes
Opening a Base
As preparation for changing the Channel on a Base Station or changing
to the base to operate as a Relay, the case must be opened to expose the
circuit board with the switches and jumpers. Be sure you disconnect
power before opening the case.
Turn your Base Station upside-down, and unscrew its single phillips
head screw. If you don't completely remove the screw, you can use it as
a lever to pull up on the cover.
Otherwise, insert a fingernail, credit card edge or small screwdriver
blade into the gap between the Base and side of the case, and gently use
it as a lever to lift up the edge of the Base. Then grasp the edge of the
Base and open it outward like a door.
Changing a Base to a Relay
Moving the jumpers to any of the Relay positions causes the Base
Station to operate as a Relay. A Base station blinks green on power up;
a Relay blinks yellow on power up.
