Woodward easYgen-1800, Руководство по эксплуатации

Страница: 28 / 38

No Type Description
14 Gen. reverse power If reverse power detection is enabled, when the controller detects that the reverse
power value (power is negative) has fallen below the pre-set value and the action select
“Warn”, it will initiate a warning alarm.
15 Overload If over power detection is enabled, when the controller detects that the over power value
(power is positive) has exceeded the pre-set value and the action select “Warn”, it will
initiate a warning alarm.
16 ECU warning alarm If an error message is received from ECU via J1939, it will initiate a warning alarm.
17 Gen. loss of phase If loss of phase detection is enabled, When controller detects the generator loss phase,
it will initiate a warning alarm.
18 Gen. phase rotation mismatch When the controller detects a phase rotation error, it will initiate a warning alarm.
19 Breaker open/close fail When the controller detects that the breaker close or open failure occurs, and the action
select “Warn”, it will initiate a warning alarm.
20 Temperature sensor wire break When the controller detects that the temperature sensor is open circuit and the action
select “Warn”, it will initiate a warning alarm.
21 High temperature When the controller detects that engine temperature has exceeded the pre-set value, it
will initiate a warning alarm.
22 Low temperature When the controller detects that engine temperature has fallen below the pre-set value,
it will initiate a warning alarm.
23 Oil pressure sensor wire break When the controller detects that the oil pressure sensor is open circuit and the action
select “Warn”, it will initiate a warning alarm.
24 Low oil pressure When the controller detects that the oil pressure has fallen below the pre-set value, it
will initiate a warning alarm.
25 Fuel level sensor wire break When the controller detects that the level sensor is open circuit and the action select
“Warn”, it will initiate a warning alarm.
26 Low fuel level When the controller detects that the fuel level has fallen below the pre-set value, it will
initiate a warning alarm.
27 Analog input 4 Wire break When the controller detects that the flexible sensor 1 is open circuit and the action
select “Warn”, it will initiate a warning alarm.
28 Analog input 4 High limit When the controller detects that the sensor 1 value has exceeded the pre-set value, it
will initiate a warning alarm.
29 Analog input 4 Low limit When the controller detects that the sensor 1 value has fallen below the pre-set value, it
will initiate a warning alarm.
30 Analog input 5 Wire break When the controller detects that the flexible sensor 2 is open circuit and the action
select “Warn”, it will initiate a warning alarm.
31 Analog input 5 High limit When the controller detects that the sensor 2 value has exceeded the pre-set value, it
will initiate a warning alarm.
32 Analog input 5 Low limit When the controller detects that the sensor 2 value has fallen below the pre-set value, it
will initiate a warning alarm.
33 Discrete input xyz When digit input port is set as warning and the alarm is active, it will initiate a warning
alarm.
34 GSM Communication fail When select GSM enable but the controller couldn’t detect GSM model, controller sends
corresponding warning signal.
35 Ground fault If earth fault detection is enabled, when the controller detects that the earth fault current
has exceeded the pre-set value and the action select “Warn”, it will initiate a warning
alarm.
4.1.3 Shutdown Alarms
When controller detects shutdown alarm, it will send signal to open
breaker and shuts down generator.
Appendix
Alarms and Warnings > Shutdown Alarms
37690A easYgen-1800 | Genset Control 28