Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
++49 (0)7152 / 9939 - 40
Internet: www.widos.de
email: [email protected]
08.10.14 Working
instructions
WIDOS RSC 2000
Page 14 of 63
3. Functional description
B a s i c a l l y , t h e i n t e r n a t i o n a l a n d n a t i o n a l p r o c e s s g u i d e l i n e s a r e t o b e
f o l l o w e d .
After its activation, the saw drives into reference position (chapter: 5.2).
Adjust the saw to the requested angle and secure it by clamping / latching.
Shift the pipe onto the pipe supports and clamp tightly (check distance to the cutting chain!).
Switch on the line laser.
Switch on the vacuum device.
Having finished all adjusting work, start the travel motor and drive the cutting chain towards the
pipe stopping shortly in front of it.
Afterwards start the cutting chain and cut the pipe through.
Having finished the cutting, drive the cutting chain behind the pipe and shut it off.
The line laser switches off.
The vacuum switches off.
Now remove the remaining chips, unclamp the pipe and remove it.
The cutting is completed.
