Kunststoffschweißtechnik
Maintenance / Storage / Transport
Chapter 6
08.10.14 Working
instructions
WIDOS RSC 2000
Page 32 of 63
6.3. How to align the saw
Supporting holders are mounted at the swing arm in order to be guided on the swing rail. The
supporting holders each have four bearing rollers / curved rollers between which the swing rail
is guided.
Align the swing arm by the leveling feet in the base frame and in the swing rail.
You may carry out the fine adjustment by the set and fit screws in vertical and horizontal
direction.
In order to align detach the fit screws.
Then slightly detach or tighten the fixing screws.
Check the position of the table and the swing arm by a water level; in case both the swing
arm and the table are vertical as well as horizontal, then tighten the fit screws again.
Afterwards, swivel the swing arm manually in order to check a correct running of the rollers.
6.4. How to maintain and replace the cutting chain
Spray the cutting chain once per day using a multifunctional PTFE spray (e.g.
Interflon fine super / Caramba / Weicon).
Regularly remove the planing chips from the chain, do not blow the chips
away by compressed air.
Risk of injury!
The saw teeth are very sharp, necessarily wear safety gloves!
We recommend that you consult a second person in order to replace the cutting
chains.
Swing arm
Supporting holder
Swing rail
Set screw
Fit screw
