Kunststoffschweißtechnik
Starting
and
operating
Chapter 5
08.10.14 Working
instructions
WIDOS RSC 2000
Page 26 of 63
5.2. How to switch on the saw
Switch on the main switch and wait until the display is illuminated (the PC is being initialized).
Display:
2
nd
line:
WIDOS GmbH
Germany
after a few seconds, the display changes
Display:
2
nd
line:
WIDOS GmbH
Loader V11.20
after a few seconds, the display changes
Display:
2
nd
line:
version 4.02.02
serial no. 1110002
Number of the software version
Serial number of the machine
after a few seconds, the display changes
Display:
2
nd
line:
WIDOS RSC 24
Welcome XXXX
after a few seconds, the display changes
Display:
2
nd
line:
Tables REFERENCING
Keep <Start> pressed (chapter: 4.2.1) until you hear the signal; the saw
drives into initial position
Display:
2
nd
line:
693 rpm 690 rpm
-2894.4mm 0.00
Display:
Rotary speed saw motor / rotary speed saw travel
Distance travel from pipe center / angle
5.2.1. How to calibrate angles
Display:
2
nd
line:
0 rpm 0 rpm
-2894.4mm 0.00
Display: Rotational speed of saw motor / rotational
speed of saw travel
Distance to pipe center / angle
In case the saw is not in 0° position, release the resting cylinder
or
clamping cylinder
by which the saw is locked.
