Westinghouse WPX2700, Инструкция по эксплуатации

Страница: 16 / 48

Required Fuel – Use only unleaded petrol with an
octane rating not less than 91 and ethanol content not
greater than 10%. Where possible it is preferable to
use regular unleaded petrol without ethanol.
Filling the Fuel Tank –
Follow the steps below to fill
the fuel tank:
1. Stop the pressure washer, if running.
2. Allow the pressure washer to cool down until the
muffler cover is cool to the touch.
3. Move the pressure washer to a flat surface.
4. Clean area around the fuel cap.
5. Remove the fuel cap by unscrewing it anti-
clockwise about 1/3 of a turn.
6. Slowly add fuel into the fuel tank. Be careful
not to overfill the tank. The fuel level should
not be higher than the bottom of the filler
neck as indicated by the red-coloured marker
(see Figure 14).
7. Replace the fuel cap by screwing it clockwise
about 1/3 of a turn until it reaches the limit stop.
NOTE: For ease of replacing the fuel cap, check
that the two notches in the top rim of the
fuel strainer are aligned with the two notches in
the fuel tank filler neck as shown in Figure 14.
14.
Figure 14 – Maximum Fuel Fill Level
ADDING DETERGENT
WARNING
Use only biodegradable, non-
flammable and non-toxic pressure
washer detergent added via the
detergent tank and not pre-mixed
into the water supply. Do not use
any acid, alkali, flammable solvent,
insecticide, poison or other harmful
toxic substance that can cause
physical injury by contact, ingestion or
inhalation.
Use only water-soluble liquid cleaning detergent that
is approved by its manufacturer for spray application.
Check the instructions to determine whether undiluted
detergent can be added straight into the detergent
tank or if it needs to be pre-mixed with water.
When applied via the pressure washer, the liquid
drawn from the detergent tank is automatically diluted
with water in a ratio of approximately 1 part detergent
to 20 parts water before it is sprayed out through the
detergent nozzle.
Filling the Detergent Tank –
Follow the steps below
to fill the detergent tank:
1. Stop the pressure washer, if running.
1. Open the cap on the detergent tank by pulling
upwards on the cap’s lift tab.
3. Slowly add detergent into the tank as shown in
Figure 15 until the detergent level is about 5 cm
below the top of the filler neck. Do not overfill.
4. Check that the breather hole in the top of the cap
is unobstructed.
5. Replace the cap by pushing it downwards on top
of the filler neck until it snaps closed.
Figure 15 – Adding Detergent
12