Westinghouse WPX2700, Инструкция по эксплуатации

Страница: 21 / 48

PRESSURE WASHING TIPS
NOTICE
Damage may occur to the cleaning surface if the
spray nozzle is held too close to it, especially when
using the medium and high pressure nozzles.
If in any doubt about the durability of the surface to
be cleaned, test wash a small inconspicuous area
first and check for any adverse water erosion or
penetration.
To avoid damage when cleaning tyres, do not use
the red (0°) spray nozzle and do not spray closer
than 30 cm (1 ft).
For best results, keep the spray nozzle between 15 to
20 cm (6 to 8 in) away from the surface being cleaned
and hold the lance at a 45° angle as shown below .
Figure 22 – Spray Gun Lance Orientation
When beginning to pressure wash, start with the lance
at least 60 cm (2 ft) away from the surface and then
gradually move it closer if necessary while checking
for any surface damage.
APPLYING DETERGENT
NOTICE
Use only the black (60°) very low pressure spray
nozzle for applying detergent. The other higher
pressure nozzles will not dispense detergent.
1. Install the black (60°) spray nozzle.
2. Check the detergent tank level and add detergent,
if required, in accordance with the Adding
Detergent instructions herein.
3. Turn on the water supply and start the pressure
washer.
4. Apply the detergent to the surface working
upwards from the bottom to the top in long, even
and overlapping strokes.
5. Allow the detergent to soak in for a few minutes,
but do not let it dry to prevent staining or
streaking of the surface.
NOTICE
After using detergent, refill the detergent tank
with clean water and spray it out using the black
nozzle until the tank is empty. This flushes out
the detergent and prevents it from drying out and
clogging the detergent siphon tube and orifices.
PRESSURE WASHING OR
RINSING
1. Install either the red (0°), yellow (15°) or green
(25°) spray nozzle for medium to high intensity
washing. Or install the white (40°) spray nozzle for
low intensity rinsing.
2. Wash or rinse the surface working downwards
from the top to the bottom in overlapping strokes.
3. Always start with the lance at least 60 cm (2 ft)
away from the surface and then gradually move it
closer if necessary while checking for any water
damage.
15-20 cm (6-8 in)
Direction of Cleaning
`17