Westinghouse WPX2700, Инструкция по эксплуатации

Страница: 22 / 48

18
AFTER EACH USE
1. Switch off the pressure washer and turn off the
water supply.
2. Add approximately 0.5 L of clean water into the
detergent tank using the water supply hose to
bring it to a level of about 1/3 full.
3. Install the black (60°) spray nozzle.
4. Turn on the water supply and start the pressure
washer.
5. Pull the spray gun trigger continuously for
several minutes until all of the water and traces
of detergent have been siphoned out of the
detergent tank and flushed through the pump,
high pressure hose and spray gun. This can be
monitored by observing the flow of liquid through
the detergent siphon tube.
6. Switch off the pressure washer and turn off the
water supply.
7. Point the spray gun in a safe direction and pull
the spray gun trigger to relieve any confined water
pressure.
8. Disconnect the water supply hose and the high
pressure hose.
9. Drain any remaining water out of the pressure
hose, spray gun and lance.
10. Coil up the pressure hose on its holder.
11. Engage the trigger lock on the spray gun and
return it and the lance to their respective storage
positions on the pressure washer.
12. While the pressure washer is switched off, pull
the recoil starter handle five times to remove any
remaining water from inside the water pump.
13. Allow the pressure washer to cool down if the
engine is still hot to the touch.
14. Wipe down the pressure washer with a rag or
chamois.
15. Store the pressure washer in a clean, dry and well
ventilated place that is not subject to freezing
temperatures.
TRANSPORTING THE
PRESSURE WASHER
The pressure washer should be switched off and the
fuel valve lever should be moved to the OFF position
before transporting the unit. Keep the pressure
washer upright during transport to minimise the
possibility of fuel leakage and preferably drain out the
fuel prior to transport.
If the pressure washer has been operating, allow
the unit to cool down before loading it onto the
transport vehicle. The pressure washer’s wheels are
only intended for moving the unit around by hand.
The wheels are not suitable for towing the pressure
washer either on or off-road.
Use only the pressure washer’s frame for lifting the
unit or attaching any load restraints such as ropes
or tiedown straps. Do not attempt to lift or secure
the pressure washer by holding onto any of its other
components.
Loose accessories such as the high pressure hose,
spray gun and lance, spray nozzles and nozzle
cleaning tool should be removed from the pressure
washer and stowed securely for transport.
The handle can be removed, if necessary, to reduce
the overall height of the pressure washer for ease of
transport. The procedure to remove it is the reverse
of that to install it as described in the Assembly
instructions herein.