Westinghouse WPX2700, Инструкция по эксплуатации

Страница: 12 / 48

8
WHEELS
CAUTION
Never lift the pressure washer without
assistance. The pressure washer is
heavy and lifting without assistance
can result in personal injury.
Never use the handle as a lifting
point to support the entire weight of
the pressure washer. Only use the
handle to lift the pressure washer
while simultaneously lifting it from
underneath the chassis frame. The
handle can also be used to move the
compressor around on its wheels.
NOTICE
Assembling the pressure washer will require tipping
the unit over onto one of its sides and then the
other. Make sure all engine oil and fuel are drained
from the unit prior to assembling.
Once assembled, the wheels are not intended for
towing the pressure washer either on or off-road.
The wheels are designed for use on this pressure
washer only.
Never tip the pressure washer over after it has been
fully assembled and filled with oil and fuel.
1. Place pressure washer chassis on a flat surface if
not already on the base of its shipping carton after
unpacking.
2. Place a piece of cardboard or other soft material
on the ground and tip the pressure washer over
onto its side. This should protect the frame from
being scratched and stop it from sliding about on
the ground.
3. Insert an axle through one of the wheels from the
recessed hub side. Then insert the protruding axle
through the axle bracket on the frame under the
engine.
4. Insert the straight leg of one R-clip through the
hole in the end of the axle as shown in Figure 4.
5. Repeat steps 2, 3 and 4 using the other wheel,
axle and R-clip.
1 - Wheel
2 - Axle
3 - R-Clip
4 - Axle Bracket
Figure 4 – Attaching Wheel to Frame
HANDLE
1. Position the handle with its connecting female
tube ends located vertically above the male
tube ends protruding upwards from the pressure
washer chassis frame. See Figure 5.
2. Lower the female tube ends onto the male tube
ends. Push in the spring-loaded locking buttons
and keep lowering until the locking buttons
engage with the holes in the female tube ends.
1 - Handle
2 - Frame
3 - Locking Button
Figure 5 – Attaching Handle to Frame
1
3
4
2
3
3
1
2