WEIHONG NK105 G2F, Руководство производителя

Страница: 60 / 89

Specialized Concentrated Focused
「
48
」
Machining Operation of NK105G3F
5. Machining Operation of NK105G3F
5.1. Manual Machining
Manual machining refers to manipulating a machine tool by the direction keys of the three axes on the
panel. At the same time, parameters including the operation speed and step length can also be adjusted
according to the requirements of operation.
After backing to the reference point, the system will enter into the manual state automatically, the screen
display as shown in Fig. 5-1.
1 X 0 .0 0 0 Id le
1 Y 0 .0 0 0 S O ff
1 Z 0 .0 0 0 S lo w
J o g 1 0 0 %
Fig. 5-1 Manual machining interface
5.1.1.
Mode Selection of Manual Machining
Refer to chapter 4.8.1 for details.
5.1.2.
Parameter Setting of Manual Machining
Refer to chapter 4.8.2 for details.
Where:
Press
5
to switch between jog speed (manual low speed) and rapid jog speed (manual high
speed).
Press
(X,Y)
0
(0,0)
to switch between USB file and C file list.
5.2. Automatic Machining
Automatic machining refers to that the system processes system files and the files in the USB flash drive
in terms of instructions, also called file machining. All the parameters of machine tool and system should
be set correctly before automatic machining starts.
5.2.1.
Load File
For details, refer to chapter 4.9.2.