WEIHONG NK105 G2F, Руководство производителя

Страница: 6 / 89

Specialized Concentrated Focused
「
IV
」
Preface
WARNING
plugging or touching switch;

The connecting wire should not be damaged and squeezed, or the leakage or short circuit may
occur;

It is prohibited to plug or open the chassis of CNC device when power on.
4) Precautions Related to Running & Debugging

Parameters setting should be checked before running, since wrong setting may lead to
accidental movements;

Modification to parameters should be within the allowable range, or such breakdowns as
unsteady running and machine damage will occur.
5) Precautions in Use

Before power-on, please make sure that the switch is on blackout to avoid occasional start-up;

Please check the electromagnetic compatibility during electrical design in order to avoid or
reduce electromagnetic interference to the CNC device. A low pass filter should be employed
to reduce electromagnetic interference if there are other electrical devices nearby;

It is not allowed to frequently power on and power off. It is recommended to power up the
machine again at least one (1) minute later after power failure or blackout.
CAUTION
1) Precautions Related to Product and Manual

Matters related to restrictions and functions available stipulated in the manuals issued by the
machine manufacturer are prior to those in this manual;

This manual assumes all the optional functions are available, which you must confirm through
manuals issued by the machine manufacturer;

Please refer to manuals issued by the machine manufacturer for the instructions of machine
tools;

Functions, and software interfaces vary with the system and the version of software. Before
using the system, you must confirm the specifications.