WEIHONG NK105 G2F, Руководство производителя

Страница: 29 / 89

Specialized Concentrated Focused
System Page
「
17
」
3. System Page
Manual operation mode is activated by default when the system is started. Default interface is machining
page, on which axis, coordinate, operating state, spindle state, manual speed as well as operation mode
are displayed, as shown Fig. 3-1. Besides, tips for operation will be shown on bottom part of the page.
1X 0.000 空闲
1Y 5.994 轴停
1Z 1020.490 低速
连续 100%
●
●
●
●
●
●
●
Operation mode
（
Feedrate override
）
Axis
Spindle state
System state
Manual speed type
Feedrate override
Axis coordinates
Fig. 3-1 Machining page
3.1. Operation Mode and State
3.1.1.
Operation Mode
All of the operation modes are listed below and a good understanding of them is vital for proper
operation.

Auto Mode
Under automatic operation mode, the machine tool generates motions according to the file loaded in
advance. Therefore, the machining file must have been loaded.

Manual Mode
To meet the requirements of manual motion under different situations, the system provides
―Jog‖ and
―Stepping‖ modes, which can be switched freely by pressing
.

Jog mode: this mode is fit for tuning machine coordinates roughly without concrete step-size.

Stepping mode: this mode is applicable to tuning machining coordinates accurately.
3.1.2.
Operation State
All of the operation states are listed below; operation mode and operation state together decide the state
of the machine tool.