Weathermatic SmartWire 9600TW, Руководство пользователя

Страница: 38 / 48

32
http://support.weathermatic.com
13.0 Troubleshooting the SL9600TW Module
13.0 Troubleshooting the SL9600TW Module
The SL9600TW provides special key combinations that can
be used to access special features and information that can be
helpful during the diagnostic process. These key combinations
are as follows:
o Push Up Arrow and Down Arrow simultaneously to view
the software version for your SL9600TW.
o Push Select Mode and Up button simultaneously, then
release and use Up and Down buttons to select a zone,
then push the Program Zone button to view the software
version for that particular decoder.
o Hold down Select Mode button for 5 seconds and release
to initiate a quick test of all zones. When using the test
mode, zone addresses will be displayed while the zone
is operating. If multiple zones are operating, the zone
addresses will be displayed rotating every three seconds
until the zone is turned off.
o Push Program Zone and Up button simultaneously to view
the SL9600TW temperature.
If an over current or over temperature is sensed by the
SL9600TW decoder programmer, it will cause a FAULT
message to appear on the display of the SmartLine® controller.
Open the SmartLine® panel and check the FAULT on the display
of the SL9600TW decoder programmer. Aer the FAULT is
repaired, press the Program Zone button on the SL9600TW to
clear the error message. Refer to the table below for SL9600TW
error messages and corresponding corrective actions.
• Decoder Locating: To use a 521 locator to find a decoder, the
decoder should be turned on by the controller and located
using the 521 wand (patent pending).
• Valve Locating: Use the SL9600TW controller Advanced
Functions menu options for the valve locator to find the
valve. This feature will create a “chatter” for a selected
valve as a convenient method of locating buried valves. Use
NEXT and BACK buttons to scroll to the valve you want to
“chatter.”