Weathermatic SmartWire 9600TW, Руководство пользователя

Страница: 30 / 48

24
http://support.weathermatic.com
10.0 Advanced Menu
10.6.3 DELAY
This feature allows the user to adjust the factory set 48 hour
watering delay that will occur after a rain event shutdown if
you are using an SLW Weather Sensor. To eliminate the delay
or to reduce or increase the factory default hours, turn the dial
to Advanced Menu and use the UP and DOWN button to select
SLW DLY. Press the NEXT button and 48 hours will show in the
display. Use the UP and DOWN buttons to eliminate the delay
or to select a different number of hours (0–99 hours). Note: The
SLW DLY begins after the SLW rain sensor has reset following a
rain event. Accumulation of new water deficits will not begin until
after the SLW DLY has cleared.
10.7 MIN DEF
This feature allows a Minimum Deficit to be set. The feature
requires that a zone deficit be greater than the MIN DEF setting
in order to run during a scheduled program. The setting is global
for all zones in SMART. The range for the global setting is 0.00
to 0.50 inches. The factory default is 0.15 inches.
10.8 SENSOR
Sensor is an ON/OFF toggle to override the SEN terminals rain/
freeze functions on selected zones. Factory default is ON.
10.9 RUN/SOAK
The purpose of Run/Soak is to break up long run times that
often cause wasteful runoff. The Run/Soak is programmable for
each program if you are using the BASIC watering mode. Note:
If you are using SMART, these inputs are not used since the Run/
Soak period is automatically calculated.
Use NEXT button to access RUN time allowed before the zone
watering pauses for the specified soak time. Use PGM button
to select program. Use UP and DOWN buttons to set RUN time
from OFF to 30 minutes (SmartLine™ controller default is OFF).
Use NEXT button to access soak time required for water to
infiltrate into soil before zone watering is continued. Use the UP
and DOWN buttons to set soak time from 1 minute to 2 hours in
one-minute increments.
10.10 DS TIME
Your SmartLine® controller can automatically adjust the time for
daylight saving time (DST). The factory default setting is OFF
and has been preset for the current USA schedule. To turn DST
adjust ON, press the next button at DS TIME, the NEXT button at
ON/OFF then select ON.
The DS Time feature can be customized to match any
international DST schedule. Press the NEXT button at DS
TIME in advanced functions. Select DS SETUP and press the
NEXT button again. You will be prompted to enter the START
schedule (time of day is moved ahead 1 hour per START
schedule), and the STOP schedule (time of day is moved back
1 hour per STOP schedule). DST start and stop are formatted
with the the Week (first, second, third, last), the Day (Sun-Sat)
and the Month (Jan-Dec). All DS Time adjustments are made at
2 am. To return the DS Time schedule back to the USA factory
default, use the US DEFLT option.
10.10.1 DST ON/OFF
If you would like for your controller to automatically set the time
of day on the occurrence of Daylight Saving Time, make sure it is
turned on in this menu
10.10.2 DS SETUP
Your controller is programmed with the a default of starting
Daylight Saving Time starting on the second Sunday in March