The ANGEL should only be cleaned
externally using a synthetic oil moistened
cloth. Under no circumstances should you
use hydrocarbon based oils, as these will
cause irrevocable damage to the internal
seals, e.g.: WD40, Vaseline, Duck Oil,
Engine oil, Plus Gas, 3in1. The suitable oil
is Angel Love Juice Oil.
The ram shaft and internal parts that are
accessible during disassembly and
re-assembly should be lubricated with
Angel Love Juice Extreme Grease.
The frequency of lubrication should be
every event or at least 8000 shots for oil
lubrication and 20,000 shots for grease
lubrication. The ANGEL should never be
immersed into water otherwise damage
may occur to the electronics.
Ensure correct tools are used.
IMPORTANT NOTES:
• No solvents or abrasive cleaning
products should be used. All external
and internal accessible moving parts
should be lubricated using light
synthetic oil only.
• All threads on the Angel, except those
for the Angel accessory mountings at
the base of the grip frame (see below),
are metric.
Angel accessory mountings use
industry standard 10/32 UNF at
centres 0.75” (20mm).
When inserting screws in to the bottom
of the grip frame - the screw thread
length must not exceed 0.375” (10mm)
otherwise damage will occur to the
electronics.
We recommend that you remove the
right-hand cheek cover and battery
when inserting these screws and ensure
that the screws do not project into the
circuit board cavity when fitting.
General assemblies
SOLENOID
VOLUME
CHAMBER
MAINTENANCE
PLUG
EXHAUST VALVE
FORE GRIP
QR LOW RISE
GRIP CHEEK
END PLUG
LPR
GRIP FRAME
ASA ADAPTOR
TRIGGER
BACK PLATE
VOLUME CHAMBER COVER
EYE RIBBON COVER
RUBBER FINGER DETENTS
FORE GRIP SEAL
END PLUG RETAINING PIN
