0
In-line regulator service & assembly
The mini-regulator is a second stage regulator that
is used to control the velocity and regulate the gas
pressure. It can be deleted, but only if a suitable
first stage regulator is used that incorporates a high
flow and good regulation properties across the tank
pressure range.
•
Remove the macro line hose from the mini
regulator by following the procedure and warnings
given in PROPELLANT AIR/NITROGEN SUPPLY
•
Remove the mini-regulator adjuster screw
taking care not to lose the small ball bearing.
•
Remove the mini regulator end cap
by inserting
a M4 Allen key into the macro line fitting
and
rotating counter clockwise.
•
Insert mini reg spool extraction tool
into the
threaded hole in the bottom of the spool and gently
extract the spool
.
•
Remove the circlip
located in the spool using
suitable circlip pliers.
•
Invert the mini-regulator spool and tap it down
firmly onto a smooth surface to shock the internals
out of the mini-regulator body.
•
Ensure the large piston
, Spring stack
, small
piston
, and the ball bearing
0
are removed.
•
Inspect the O rings
for damage and replace
if necessary.
•
Inspect the small piston
face seal for damage
and replace the whole small piston if necessary.
•
Inspect the large piston
and small piston
sealing faces for damage and replace as
necessary.
Note: If replacement of the macro line hose
connector is required remove the regulator end
cap from the fore grip before attempting to replace
the fitting. Failure to do so can result in damage
to regulator end or the fore grip.
0
SPRING STACK
ORDER
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
