ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
Ram removal
•
Ensure the ANGEL is de-gassed and switched OFF
or the ANGEL is in SAFE mode.
•
Rotate the breech release knob
clockwise until
it stops (see page 7).
•
Swing out the Rotor Breech block
so that the
bolt is exposed.
NOTE: the breech will not open unless the bolt is
in the backward position.
•
Remove the screw located in the centre of the back
plate
, using a suitable 2mm Allen key.
•
Carefully lift the back plate off
.
•
Remove the breech release knob
by unscrewing
the locking screw
counter-clockwise.
•
Remove the right hand grip cheek cover
by
removing the 3 retaining screws using a metric
2mm Allen key.
•
Unplug the Angel Eyes, battery and solenoid
plugs
.
•
Remove the 2 grip frame screws
holding
the frame to the body using a suitable 3mm
Allen key.
•
Remove the grip frame
from the body.
•
Withdraw the ram lock pin
0
located under
the frame. The ram
can now be withdrawn
as an assembly.
IMPORTANT NOTES:
For re-assembly of components
•
Ensure the ram assembly is lubricated with
Love Juice Extreme Grease prior to re-fitment.
•
Ensure the ram assembly external O rings are
not damaged.
•
Ensure the ram
assembly is
inserted slowly
to prevent
damage to the
O rings.
0
NOTE: WHEN RECONNECTING THE EYE RIBBONS
TO THE PCB THE SHORTER RIBBON CONNECTS
TO TOP ZIFF SOCKET.
