MODES
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted to
the ANGEL.
· Ensure the hopper is removed from the
ANGEL.
· Ensure that there are no paintballs in the
ANGEL.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
To activate the break-out feature press the navigation
switch inwards, the alarm will momentarily sound to
indicate that the break-out mode has been initiated.
In order for the Angel to start firing in the break-out
mode once it has been initiated the trigger must be
pulled and held in within the time period that the
break-out mode is active. The duration of the time
period that the break-out mode is active can be
adjusted. The range for this adjustment is 1 – 20
seconds. If the trigger is released at any point once
the break-out mode has been initiated or the time
period of the break-out elapses the break-out mode
will revert to the previously selected mode.
Ramp
There are 2 Ramp modes that can only be used when
the Angel is in custom semi mode, Soft ramp and
Hard ramp.
There are 3 Parameters that can be adjusted to
custom tune the ramp modes.
Start delay: This is the number of shots fired before
the ramp mode starts. The range for the start delay
is 1– 20 shots.
Kick in point: This sets the minimum number of
trigger pulls per second that must be reached in
order for the software to add shots. The range for the
start delay is 1 – 20 trigger pulls per second.
Drop out point: This sets the minimum number of
trigger pulls per second that must be maintained in
order for the software to add shots. The range for
the drop out point is 1 - 20 trigger pulls per seconds.
Should the number of trigger pulls drop below this
rate for more than 1 second the software will no
longer add shots until the kick in point has been
re-achieved.
To enable any of the ramping features it must be
selected from the custom modes menu.
Valve dwell
Dwell controls the valve opening time.
Longer dwell uses more gas and generates pressure
variables. Shorter dwell uses less gas and reduces
noise but is less tolerant of poor quality paint and can
result in weak shots. The range of adjustment that is
available is from 6 milliseconds to 15 milliseconds
in 0.5 millisecond increments.
Important Note:
Internal lock button must be used to turn Dwell
options on or off.
•
Ensure that the Angel is switched on
•
Ensure that you are not activating the trigger
•
Push and hold the navigation switch UP or DOWN
for 1.5 seconds
•
The
Status
menu will be displayed
•
Push the navigation button up to highlight the
i
Parameters
menu
•
Push the navigation switch in to select the
Parameters menu
•
From the
Parameters
menu select the
Dwell
feature by pushing the navigation switch inwards.
•
Scroll up or down through the dwell settings by
pushing the navigation switch up or down.
•
Once the desired setting has been reached press
the navigation switch inwards to save the new
setting.
•
A
Saved Dwell
message will be displayed.
The
Parameters
menu will be displayed.
De-Bounce
This is the length of time that the trigger has to be
pulled for it to be accepted by the electronics as a
valid trigger activation.
There are 20 levels of adjustment 1 being the least
sensitive 20 the most sensitive adjustment.
•
Ensure that the Angel is switched on.
•
Ensure that you are not activating the trigger.
•
Push and hold the navigation switch UP or DOWN
for 1.5 seconds.
•
The
Status
menu will be displayed.
•
Push the navigation button up to highlight the
i
Parameters
menu.
Parameters -
Valve dwell - De-Bounce
