22
ANGEL G7
© 2005 WDP LTD.
MAINTENANCE
VERNIER TRIGGER WHEEL REMOVAL
• Ensure a barrel blocking device is fitted to the ANGEL.
• Ensure the hopper is removed from the ANGEL.
• Ensure that there are no paintballs in the ANGEL.
• Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL before disassembly.
• The ANGEL can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction
to relieve this residual gas pressure.
• Never adjust your trigger so fine that accidental discharge can occur due to
shock loads or vibration.
WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
IMPORTANT NOTES: For re-assembly of components
• Should you be unsure of the original position of the vernier wheels follow the
procedure listed below for re-assembly.
• Ensure the vernier wheel locking screws
1
are backed off by rotating
counter clockwise.
• Ensure the vernier trigger toe adjuster screw is backed off by rotating
counter clockwise.
• It is important that the vernier wheels are inserted in position
A
shown
above, wheel
5
with the small magnet towards the back of the ANGEL.
Wheel
6
with the large magnet towards the front of the ANGEL, this is to
ensure that you start with maximum range of adjustment
• Verify the correct vernier wheel position by the indicators on the wheels
5
• Re-attach the frame.
• Ensure no wires become trapped between the body and grip frame during
re-assembly.
• Ensure the plugs are located in the correct sockets.
• Adjust the trigger as VERNIER TRIGGER ADJUSTMENT - Page 18.
1
1
2
3
3
A
A
1
1
6
5
4
6
5
7
• Undo the vernier wheel lock screws
1
using a suitable allen key.
• Important: Note the vernier wheels position prior to removal.
• Remove the grip cheek cover by removing the 6 retaining screws and using a
metric 2.5mm A/F Allen key.
• Unplug the Angel Eyes, battery and solenoid plugs
2
.
• Remove the 2 grip frame screws
3
holding the frame to the body using a
suitable 3mm A/F Allen key.
• Remove the grip frame
4
from the body.
• Gently remove the vernier wheels
5
,
6
from the body.
• Remove the vernier wheel ratchet plates
7
and inspect for damage.
Vernier Trigger Removal
