20
ANGEL G7
© 2005 WDP LTD.
MAINTENANCE
• Ensure a barrel blocking device is fitted to the ANGEL.
• Ensure the hopper is removed from the ANGEL.
• Ensure that there are no paintballs in the ANGEL.
• Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL before disassembly.
• The ANGEL can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction
to relieve this residual gas pressure.
WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
RAM REMOVAL
• Ensure the ANGEL is de-gassed and switched OFF.
• Ensure the ANGEL isolator switch is in the OFF position or the ANGEL is in
SAFE mode.
• Rotate the breech lock lever
1
clockwise until it stops.
• Swing out the Rotor Breech block
2
so that the bolt is exposed.
NOTE the breech will not open the Angel is degassed and the bolt is in the
forward position.
• If the bolt is in the forward position even if the breech lock lever has been
rotated either ensure the angel is gassed up or push the bolt back with a
squeegee.
• Remove the breech lock lever by unscrewing the locking screw
3
counter-clockwise.
• Remove the screw located in the centre of the back plate
4
, using a suitable
2.0mm A/F metric Allen key.
• Carefully lift the back plate off
5
.
• Remove the grip cheek cover
7
by removing the 6 retaining screws
using a metric 2.5mm A/F Allen key.
• Unplug the Angel Eyes, battery and solenoid plugs.
• Remove the 2 grip frame screws
8
holding the frame to the body using
a suitable 3mm A/F Allen key.
• Remove the grip frame
9
from the body.
• Withdraw the ram lock pin located under the frame. The ram can now
be withdrawn as an assembly.
5
4
2
1
3
IMPORTANT NOTES: For re-assembly of components
• There are wires and a spring located under the back plate. Care must be
taken so that the wires are not pulled or trapped during maintenance.
• Ensure the ram assembly is lubricated with Love Juice Extreme Grease prior
to re-fitment.
• Ensure the ram assembly external O rings are not damaged.
• Ensure the ram assembly is inserted slowly to prevent damage to the
O rings.
• See RAM STROKE ADJUSTMENT - Left, for setting the ram position.
7
8
8
9
RAM Removal
